Honda Accord 2008 Manual page 1652

07/11/02 09:31:10 61TA0000_200_0085
Glass Position Adjustment
The roof panel (A) should be even with the glass
weatherstrip (B), to within 0 1/ 1 mm
＋
(0 0.04/ 0.04 in.) all the way around. If not, make the
following adjustment:
＊０１
＋ −
0 1/ 1 mm
(0 0.04/ 0.04 in.) ＋
1. Remove the bracket cover.
2. Adjust the glass (A).
–1 Using a TORX T25 bit, slightly loosen the bolts.
–2 Move the glass up or down.
–3 Tighten all bolts securely.
＊０２
Fastener Locations
: Bolt, 4
A
3. If necessary, repeat on the opposite side.
4. Reset the moonroof control unit (see page 22-350).
ＴＡ０８ＡＢ９Ｊ３４２０００４０９０１ＭＢＡＴ００
＋ −
−
B
−
A
5 x 0.8 mm
4 N·m
(0.4 kgf·m, 3 lbf·ft)
Front
Glass Replacement
1. Close the glass fully.
2. Slide the sunshade all the way back.
3. Pry out the lid (A), remove the screw (B), and
release the hooks (C), then remove the bracket
cover (D). Repeat on opposite side. Use a
TORX T25 bit to remove the bolts (E) from the glass
brackets (F) on both sides.
Fastener Locations
B : Screw, 2 E : Bolt, 4
C
C
D
E
5 x 0.8 mm
4 N·m
(0.4 kgf·m,
Front
3 lbf·ft)
4. Remove the glass (A) by lifting it up. Do not
damage the roof panel.
A
5. Install the glass in the reverse order of removal,
then do these items:
• Do the glass position alignment procedure
(see page 20-83).
• Reset the moonroof control unit (see page
22-350).
6. Check for water leaks. Use free-flowing water from
a hose without a nozzle. Do not use high-pressure
water.
NOTE: It is normal for some water to seep past the
moonroof into the moonroof frame, and exit
through the drains.
ＴＡ０８ＡＢ９Ｊ３４２０００４０９０１ＫＢＡＴ００
A
D
B
E
F
20-83 20-83
＊０１
＊０２