Honda Accord 2008 Manual page 961

07/11/02 08:48:09 61TA0000_140_0118
Automatic Transmission
DTC Troubleshooting (cont'd)
27. Turn the ignition switch to LOCK (0).
28. Disconnect PCM connector C (49P).
29. Check for continuity between PCM connector
terminal C13 and output shaft (countershaft) speed
sensor connector terminal No. 1.
＊０６
OUTPUT SHAFT
(COUNTERSHAFT)
SPEED SENSOR
CONNECTOR
Wire side of
female terminals
Is there continuity?
YES
−
NO
connector terminal C13 and the output shaft
(countershaft) speed sensor, then go to step 30.
14-116
PCM CONNECTOR C (49P)
VCC1 (YEL/RED)
VCC1
(YEL/RED)
Terminal side of
female terminals
− Go to step 36.
Repair open in the wire between PCM
30. Reconnect all connectors.
31. Turn the ignition switch to ON (II).
32. Clear the DTC with the HDS.
33. Test-drive the vehicle at speeds over 12 mph
(20 km/h) with the shift lever in D, and let the
transmission shift through all five gears.
34. Check for Temporary DTCs or DTCs with the HDS.
Is DT C P07 23 indicated?
−
YES Check for poor connections or loose
terminals between the output shaft (countershaft)
speed sensor and the PCM, then go to step 1.
NO − Go to step 35.
35. Monitor the OBD STATUS for P0723 in the DTCs
MENU with the HDS.
Does the HDS indicate PASSED?
YES − Troubleshooting is complete. If any other
Temporary DTCs or DTCs were indicated in step 34,
go to the indicated DTC's troubleshooting.
NO − If the HDS indicates FAILED, check for poor
connections or loose terminals between the output
shaft (countershaft) speed sensor and the PCM,
then go to step 1. If the HDS indicates NOT
COMPLETED, go to step 33.