Honda Accord 2008 Manual page 1170

07/11/02 09:22:12 61TA0000_140_0327
6. Align the spring pin (A) on the selector control shaft
(B) with the transmission housing groove (C) by
turning the selector control shaft with the selector
control lever.
NOTE: Do not squeeze the end of the selector
control shaft tips together when turning the
selector control shaft.
＊０６
07HAC-PK40102
A
B
7. Install the housing puller over the mainshaft, then
remove the transmission housing.
C
8. Remove the countershaft shaft reverse gear and
the needle bearing.
9. Remove the lock bolt securing the shift fork, then
remove the shift fork with the reverse selector
together.
10. Remove the selector control lever from the selector
control shaft.
11. Unlock the detent spring (A) from the detent arm
(B).
A
B
＊０３
(cont'd)
14-325