Honda Accord 2008 Manual page 1135

07/11/02 09:20:01 61TA0000_140_0292
A/T Gear Position Indicator
Transmission Range Switch Test (cont'd)
7. Disconnect the transmission range switch
connector.
＊０４
8. Check for continuity between the terminals at the
transmission range switch connector. There should
be continuity between the terminals in the
following table for each transmission range switch
position.
Transmission Range Switch Connector
＊０５
Position/Connector Terminal/Signal Connections
P
R
N
D
D3
2
1
9. If the transmission range switch continuity check is
OK, replace the faulty transmission range switch
harness.
If there is no continuity between any terminals, go
to step 10.
14-290
1 2 3 4 5 6 7
ATP ATP ATP
N D3 P R
FWD
RVS NP
10. Remove the transmission range switch, and check
the end of the selector control shaft (A).
Selector Control Shaft Specifications:
Width (B):
End Gap (C): 1.8 2.0 mm (0.07 0.08 in.)
11. If the measurement of the selector control shaft
end is within the standard, replace the transmission
range switch (see page 14-291). If the measurement
is out of the standard, repair the selector control
shaft end, and recheck the transmission range
8 9 10
switch continuity.
ATP
D GND
2-1
6.1 6.2 mm (0.240 0.244 in.) − −
− −
A
C
B
＊０６