Countershaft Bearing Replacement - Honda Accord 2008 Manual

Hide thumbs Also See for Accord 2008:

Table of Contents

07/11/02 09:22:46 61TA0000_140_0342

Torque Converter Housing

Countershaft Bearing Replacement

Special Tools Required

• Adjustable bearing puller, 25 40 mm

07736-A01000B or 07736-A01000A

• Driver 07749-0010000

• Attachment, 62 x 68 mm 07746-0010500

1. Remove the countershaft bearing using the

adjustable bearing puller and a commercially

available 3/8 ''-16 slide hammer (A).

07736-A01000B or

07736-A01000A

2. Remove the ATF guide plate (A), and check it for

wear and damage. If the guide plate is worn or

damaged, replace it.

3. Install the ATF guide plate in the torque converter

housing, and install a new countershaft bearing (B).

4. Install the countershaft bearing securely in the

torque converter housing using the driver and the

62 x 68 mm attachment.

07746-0010500

5. Make sure that the bearing outer race notch-cut (A)

is installed at a height of 0 0.05 mm (0 0.002 in.)

(B) above the torque converter housing surface (C).

Do not install the countershaft bearing higher than

0.05 mm (0.002 in.) above the torque converter

housing surface.

ＴＡ０８ＡＥＢＥ１０４１０９１７４２４ＫＢＡＴ００

07749-0010000

Table of Contents