Honda Accord 2008 Manual page 1285

07/11/02 09:19:12 61TA0000_170_0019
Power Steering
Pump Overhaul (cont'd)
Special Tools Required
• Attachment, 32 x 35 mm 07746-0010100
• Driver 07749-0010000
Disassembly
NOTE: Refer to the Exploded View as needed during the
following procedure.
1. Remove the power steering pump (see page 17-16).
2. Remove the inlet joint and O-ring.
3. Remove the pressure control valve cap, O-ring,
pressure control valve, and spring.
4. Remove the pump housing cap and pump preload
spring.
5. Remove the pump cover, pump cover seal, and
O-rings.
6. Remove the snap ring, then remove the rotor,
vanes, cam ring, outer case, side plate, and O-rings.
7. Remove the shaft comp. by tapping the shaft end
with a soft face hammer.
8. Remove the pump seal from the pump housing.
17-18
Inspection
9. Check the pressure control valve for wear, burrs,
and other damage to the edges of the grooves in
the valve.
10. Inspect the bore of the pressure control valve on
the pump housing for scratches and wear.
11. Slip the pressure control valve back in the pump
housing, and check that it moves in and out
smoothly. If OK, go to step 12; if not, replace the
pump as an assembly. The pressure control valve
is not available separately.
＊０２
＊０３