Honda Accord 2008 Manual page 1620

07/11/02 09:29:49 61TA0000_200_0053
8. Check for water leaks. Run water over the roof and
on the sealing area as shown, and note these items:
• Use a 12 mm (1/2 in.) diameter hose (A).
• Adjust the rate of water flow as shown (B).
• Do not use a nozzle.
• Hold the hose about 300 mm (12 in.) away from
the door (C).
＊０５
12 mm (1/2 in.)
9. Reinstall the door panel:
• 2-door (see page 20-12)
• 4-door front door (see page 20-16)
• 4-door rear door (see page 20-35)
0.5 m (19 in.)
A
B
300 mm (12 in.)
C
Door Position Adjustment
NOTE: Check for a flush fit with the body, then check for
equal gaps between the front, rear, and bottom door
edges and the body. Check that the door and body
edges are parallel.
1. Place the vehicle on a firm, level surface when
adjusting the doors.
2. Adjust at the hinges (A):
• Pad a floor jack (B) with shop towels (C), then use
the jack to support the door to prevent damage to
the door while adjusting it.
• On the front door: Remove the front inner fender
(see page 20-271). Loosen the hinge mounting
bolts (D) slightly, and move the door backward or
forward, up or down as necessary to equalize the
gaps.
• On the rear door: Loosen the hinge mounting
bolts (E) slightly, and move the door backward or
forward, up or down as necessary to equalize the
gaps.
2-door
D
8 x 1.25 mm
29 N·m
(3.0 kgf·m, 22 lbf·ft)
C
B
D
8 x 1.25 mm
29 N·m
(3.0 kgf·m,
22 lbf·ft)
ＴＡ０８Ａ００Ｊ５４４０００２０３７１ＭＢＡＴ２１
A
F
8 x 1.25 mm
29 N·m
(3.0 kgf·m,
22 lbf·ft)
A
F
8 x 1.25 mm
29 N·m
(3.0 kgf·m, 22 lbf·ft)
(cont'd)
20-51 20-51
＊０６