Honda Accord 2008 Manual page 1366

07/11/02 09:28:05 61TA0000_180_0033
4. Install the damper fork (A) over the driveshaft and
onto the lower arm (B). Install the aligning tab (C)
on the damper unit into the slot (D) of the damper
fork.
＊０７
E
10 x 1.25 mm
49 N·m
(5.0 kgf·m, 36 lbf·ft)
G
12 x 1.25 mm
64 N·m (6.5 kgf·m, 47 lbf·ft)
Replace.
5. Loosely install the damper pinch bolt (E) into the
damper fork.
6. Connect the damper fork and lower arm with the
new damper fork mounting bolt (F), then lightly
tighten the new mounting nut (G).
A
B
7. Place a floor jack under the lower arm, and raise
the suspension to load it with the vehicle's weight.
8. Tighten the damper pinch bolt and the damper fork
mounting nut while holding the mounting bolt to
C
the specified torque value.
9. Tighten the damper mounting nuts and front strut
brace mounting nuts (if equipped) on top of the
damper to the specified torque values.
D
10. Install the wheel speed sensor harness bracket (A).
F
Replace.
11. Clean the mating surfaces of the brake disc and the
inside of the wheel, then install the front wheel.
12. Check the wheel alignment, and adjust it if
necessary (see page 18-5).
＊０８
A
6 x 1.0 mm
9.8 N·m
(1.0 kgf·m,
7.2 lbf·ft)
18-33