Honda Accord 2008 Manual page 1343

07/11/02 09:27:31 61TA0000_180_0010
Front and Rear Suspension
Wheel Bolt Replacement (cont'd)
Rear
1. Raise the vehicle, and support it with safety stands
in the proper locations (see page 1-9).
2. Remove the rear brake disc (see page 19-34).
3. Separate the wheel bolt (A) from the hub (B) using
the ball joint remover (C), and keep the jaw (D) of
ball joint remover vertical against the wheel bolt
(see page 18-11).
NOTE:
• If the angle of the remover against the wheel bolt
is not square, readjust the ball joint remover by
turning the head (E) of the adjusting bolt (F).
• Before installing the new wheel bolt, clean the
mating surfaces on the bolt and the hub.
＊０２
E
C
07MAC-SL0A202
18-10
B
D
4. Insert the new wheel bolt (A) into the hub (B) while
aligning the splined surfaces (C) on the hub hole
with the wheel bolt. Adjust the measurement (D)
with washers (P/N 94101-12800 or equivalent) (E),
then install a nut (P/N 90304-SC2-000 or equivalent)
(F) hand-tight.
NOTE:
• Degrease all around the wheel bolt and the
threaded section of the nut.
• Make sure the wheel bolt is installed vertically in
relation to the hub disc surface.
• Do not install the nut and washers that have been
used as tools on a vehicle.
D
11 14 mm −
(0.43 0.55 in.) −
A
F
A
5. Tighten the nut until the wheel bolt is drawn fully
into the hub. Do not exceed the maximum torque
limit. Make sure there is no gap (G) between the
bolt and the hub.
Limited torque:
108 N·m (11.0 kgf·m, 79.6 lbf·ft) max.
6. Install the brake disc (see page 19-34).
NOTE:
• If you cannot tighten the wheel nut to the
specified torque value when installing the wheel,
replace the rear hub bearing unit as an assembly.
• Before installing the wheel, clean the mating
surfaces of the brake disc and the inside of the
wheel.
F
G
C
B
E
＊０３