Honda Accord 2008 Manual page 958

07/11/02 08:48:08 61TA0000_140_0115
DTC P0723: Output Shaft (Countershaft)
Speed Sensor Intermittent Failure
NOTE:
• Before you troubleshoot, record all freeze data and
any on-board snapshot with the HDS, and review
General Troubleshooting Information (see page 14-4).
• This code is caused by an electrical circuit problem
and cannot be caused by a mechanical problem in the
transmission.
1. Turn the ignition switch to ON (II).
2. Clear the DTC with the HDS.
3. Test-drive the vehicle with the shift lever in D, with
the engine speed above 2,000 rpm, and let the
transmission shift through all five gears.
4. Monitor the OBD STATUS for P0723 in the DTCs
MENU with the HDS.
Does the HDS indicate F AILED?
YES − Go to step 5.
−
NO If the HDS indicates PASSED, intermittent
failure, the system is OK at this time. Check for
poor connections or loose terminals between the
output shaft (countershaft) speed sensor and the
PCM. If the HDS indicates NOT COMPLETED, go to
step 3.
5. Turn the ignition switch to LOCK (0).
6. Disconnect the output shaft (countershaft) speed
sensor connector, and inspect the connector and
connector terminals to be sure they are making
good contact.
Are the connector terminals OK ?
YES − Go to step 7.
−
NO Repair the connector terminals, then go to
step 7.
7. Connect the output shaft (countershaft) speed
sensor connector.
8. Test-drive the vehicle with the shift lever in D, with
the engine speed above 2,000 rpm, and let the
transmission shift through all five gears.
9. Monitor the OBD STATUS for P0723 in the DTCs
MENU with the HDS.
Does the HDS indicate F AILED?
YES − Go to step 10.
−
NO If the HDS indicates PASSED, troubleshooting
is complete. If the HDS indicates NOT COMPLETED,
go to step 8.
10. Turn the ignition switch to LOCK (0).
11. Jump the SCS line with the HDS.
12. Disconnect PCM connector C (49P).
13. Check for continuity between PCM connector
terminal C44 and body ground, and between
terminal C48 and body ground.
PCM CONNECTOR C (49P)
LG1 (BRN/YEL)
Terminal side of female terminals
Is there continuity?
−
YES Go to step 14.
NO − Repair open in the wires between PCM
connector terminals C44, C48, and ground (G101)
(see page 22-22), or repair poor ground (G101),
then go to step 30.
ＴＡ０８ＡＥＢＫ７７１０００９０７２３ＦＡＡＴ００
LG2 (BRN/YEL)
(cont'd)
14-113
＊０１