Honda Accord 2008 Manual page 1634

07/11/02 09:30:22 61TA0000_200_0067
19. With a sponge, carefully apply a light coat of body
primer to any exposed paint or metal around the
flange where new adhesive will be applied. Let the
primer dry for at least 10 minutes:
• Do not apply body primer to any remaining
original adhesive on the flange.
• Be careful not to mix up the body and glass
primer sponges.
• Never touch the primed surfaces with your hands.
＊１１
20 mm
(0.79 in.)
20 mm
(0.79 in.)
20. Cut a ''V'' in the end of the nozzle (A) on the
adhesive cartridge as shown.
＊１２
A
: Apply body primer to exposed paint as shown.
20 mm
(0.79 in.)
5 mm
(0.2 in.)
2 mm (0.08 in.)
13 mm (0.51 in.)
8 mm (0.31 in.)
21. Pack adhesive into the cartridge without air pockets
to ensure continuous delivery. Put the cartridge in a
caulking gun, and run a bead of adhesive (A) to the
windshield (B) along the edge of the molding (C)
and rubber dams (D) as shown. Apply the adhesive
within 30 minutes after applying the glass primer.
Make a slightly thicker bead at each corner.
13 mm
(0.51 in.)
2 mm
(0.08 in.)
A
C
20 mm
(0.79 in.)
2 mm
(0.08 in.)
2 mm
(0.08 in.)
2 mm (0.08 in.)
A
8 mm (0.31 in.)
A
C
2 mm
Overlap
(0.08 in.)
D
0.5 mm
(0.02 in.)
Inside
D
Inside
B
B
D
D
D
A
A
Inside
D
B
A
(cont'd)
20-65
＊１３
B