Honda Accord 2008 Manual page 1326

07/11/02 09:20:26 61TA0000_170_0060
8. Install the washers (A), the stiffener plates (B), the
new mounting bolts (C), and flange bolts on the
driver's side of the gearbox. Then loosely install the
mounting bolts and the flange bolts.
＊０４
D
10 x 1.25 mm
59 N·m (6.0 kgf·m, 43 lbf·ft)
9. Position the cutout (A) on the mounting cushion (B)
as shown, and install it on the passenger's side of
the steering gearbox.
＊０５
C
10. Install the gearbox mounting bracket (C) over the
mounting cushion, and tighten the flange bolts (D)
to the specified torque.
11. Tighten the flange bolts on the driver's side of the
steering gearbox to the specified torque alternately
in two steps.
C
14 x 1.5 mm
74 N·m
(7.5 kgf·m,
B
54 lbf·ft)
Replace.
D
10 x 1.25 mm
59 N·m
(6.0 kgf·m,
43 lbf·ft)
A
D
10 x 1.25 mm
38 N·m
(3.9 kgf·m,
28 lbf·ft)
B
A
12. Install the front subframe front stiffeners (A) and
the front subframe rear stiffeners (B), then loosely
install the new front subframe mounting bolts (C),
new flange bolts (D), and flange bolts (E).
E
12 x 1.25 mm
A
C
14 x 1.5 mm
Replace.
VSB02C000016
B
D
12 x 1.25 mm C
14 x 1.5 mm
Replace.
Replace.
13. Align the front subframe using the 15.7 mm end of
the frame positioning guide pin. Vertically install
the frame positioning guide pin, and align the right-
rear corner of the front subframe and vehicle frame
holes, then loosely tighten the subframe mounting
bolt (A) until the front subframe contacts the body
frame.
A
14 x 1.5 mm
Replace.
14. Loosely tighten the left-rear subframe mounting
bolt with the same procedure as right-rear using
the frame positioning guide pin.
A
C
14 x 1.5 mm
Replace.
B
D
12 x 1.25 mm
Replace.
070AG-SJAA10S
(cont'd)
17-59
＊０６
＊０７