Honda Accord 2008 Manual page 1320

Hide thumbs Also See for Accord 2008:

Table of Contents

07/11/02 09:20:23 61TA0000_170_0054

56. Install the new backup ring (A) on the steering rack,

then place the backup ring and cylinder end seal (B)

against the piston (C).

57. Apply steering grease to the steering rack teeth,

then insert the steering rack into the gearbox

housing. Be careful not to damage the inner

surface of the cylinder wall with the rack edges.

(08C35-B0534L)

58. Insert the an appropriate size socket wrench (A)

onto the steering rack as shown.

59. Install the backup ring (B) and cylinder end seal (C)

into the bottom of the cylinder by pressing on the

tool with a press. Do not push on the tool with

excessive force as it may damage the backup ring

and cylinder end seal.

60. Remove the tool, and center the steering rack.

61. Coat the inside surface of the new cylinder end seal

(A) and steering rack with power steering fluid,

then install the cylinder end seal onto the steering

rack with its grooved side toward the cylinder.

62. Push in the cylinder end seal with your finger. Be

careful not to damage the surface of the seal with

the threads and burrs at the staked position of the

cylinder housing.

Chapters

Table of Contents