Honda Accord 2008 Manual page 1506

07/11/02 09:35:40 61TA0000_190_0085
DTC 27-23: Steering Angle Sensor Counter
Malfunction
1. Turn the ignition switch to ON (II).
2. Clear the DTC with the HDS.
3. Turn the ignition switch to LOCK (0).
4. Start the engine.
5. Turn the steering wheel from lock-to-lock several
times.
6. Check for DTCs with the HDS.
Is DT C 27 -23 indicated?
YES − Go to step 7.
−
NO Intermittent failure, the system is OK at this
time. Check for loose terminals between the
steering angle sensor 5P connector and the VSA
modulator-control unit 36P connector. Refer to
intermittent failures troubleshooting (see page
19-47).
7. Turn the ignition switch to LOCK (0).
8. Disconnect the steering angle sensor 5P connector
(see page 19-137).
9. Disconnect the VSA modulator-control unit 36P
connector (see step 3 on page 19-142).
10. Check for continuity between steering angle sensor
5P connector terminals No. 2 and No. 4.
STEERING ANGLE SENSOR 5P CONNECTOR
STR-A (GRN)
Wire side of female terminals
Is there continuity?
YES − Repair short in the wires between the
steering angle sensor and the VSA modulator-
control unit.
NO − Go to step 11.
11. Check for continuity between steering angle sensor
5P connector terminals No. 5 and No. 2, and No. 5
and No. 4 individually.
STEERING ANGLE SENSOR 5P CONNECTOR
STR-A
(GRN)
STR-B (PUR)
Wire side of female terminals
Is there continuity?
−
YES Repair short in the wires between the
steering angle sensor and the VSA modulator-
control unit.
−
NO Go to step 12.
ＴＡ０８ＡＥ４Ｋ８０１０００Ｒ２７２３ＦＡＡＴ００
STR-B (PUR)
SVCC
(ORN)
(cont'd)
19-85
＊０１
＊０２