Honda Accord 2008 Manual page 1708

07/11/02 09:34:09 61TA0000_200_0141
Grab handle
＊２３
Sunvisor
＊２４
D
E
Roof console
＊２５
A
O
N
B
F
G
H
S
T
P
Q
P
R
Carpet Replacement
Special Tools Required
KTC trim tool set SOJATP2014
Available through the American Honda Tool and
B
Equipment Program; call 888-424-6857
One-Piece Type Carpet (4-door)/Two-Piece
Type Front Carpet (2-door/4-door)
SRS components are located in this area. Review the
SRS component locations, 2-door (see page 24-21),
4-door (see page 24-19) and the precautions and
procedures (see page 24-23) before doing repairs or
service.
NOTE:
• Put on gloves to protect your hands.
• Use the appropriate tool from the KTC trim tool set to
avoid damage when removing components.
• Take care not to damage, wrinkle, or twist the carpet.
• Be careful not to damage the dashboard and other
interior trim pieces.
1. Remove the front seat belt lower anchors from the
front seats (except 2-door driver's seat), and
remove the seat mounting bolts (see page 20-180).
2. Do the battery terminal disconnection procedure
(see page 22-89), then wait at least 3 minutes
before beginning work.
3. Remove these items:
• Front seats, both (see step 9 on page 20-183)
• Rear seat cushion (see page 20-224)
• Door sill trim, both sides, 2-door (see page 20-97)
• Front door sill trim, both sides, 4-door (see page
20-99)
• Rear door sill trim, both sides, 4-door (see page
20-100)
• Kick panels, both sides:
– 2-door (see step 5 on page 20-98)
– 4-door (see step 5 on page 20-99)
• B-pillar lower trim, 4-door (see page 20-107)
• Center console (see page 20-147)
• Steering joint cover (see page 17-28)
• Parking brake lever (see page 19-41)
• Driver's dashboard center lower cover (see page
20-156)
• Passenger's dashboard center lower cover
(see page 20-156)
ＴＡ０８Ａ００Ｊ２６２０００１６１０１ＫＢＡＴ００
(cont'd)
20-139 20-139