Honda Accord 2008 Manual page 1606

07/11/02 09:29:13 61TA0000_200_0039
10. Remove and loosen the screws from back of the
door panel (A), and release the hook (B), then
remove the armrest assembly (C).
＊０９
Fastener Locations
: Screw, 5
C
11. Remove the screws from back of the door panel (A),
and release the hooks (B, C, D), then remove the
ornament panel (E).
＊１０
Fastener Locations
: Screw, 5
A
B
D
A
B
C
E
C
12. Install the door panel in the reverse order of
removal, and note these items:
• If the clips are damaged or stress-whitened,
replace them with new ones.
• Replace any damaged cable fasteners with new
ones.
• The latch cable (A) should be fixed to the cable
fastener (B) with the latch in the unlocked
position as shown.
• Make sure the connector is plugged in properly,
and the cables are connected securely.
• Make sure the window and power door lock
operate properly.
• When reinstalling the door panel, make sure the
plastic cover is installed properly and sealed
around its outside perimeter to seal out water.
D
B
A
47 mm (1.85 in.)
＊１１
20-37