Honda Accord 2008 Manual page 1505

07/11/02 09:35:39 61TA0000_190_0084
VSA System Components
DTC Troubleshooting (cont'd)
DTC 27-21: Steering Angle Sensor Stuck
Neutral Position
DTC 27-22: Steering Angle Sensor Stuck
Offset Position
1. Turn the ignition switch to ON (II).
2. Turn the steering wheel left and right 90 degrees or
more. Check the STEERING ANGLE in the VSA
DATA LIST with the HDS.
Is there ＋ 90 ° or more, and
−
YES Intermittent failure, the system is OK at this
time. Check for loose terminals between the
steering angle sensor 5P connector and the VSA
modulator-control unit 36P connector. Refer to
intermittent failures troubleshooting (see page
19-47).
−
NO Go to step 3.
3. Turn the ignition switch to LOCK (0).
4. Disconnect the steering angle sensor 5P connector
(see page 19-137).
5. Disconnect the VSA modulator-control unit 36P
connector (see step 3 on page 19-142).
6. Turn the ignition switch to ON (II).
19-84
− 90 ° or less?
ＴＡ０８ＡＥ４Ｋ８０１０００Ｒ２７２１ＦＡＡＴ００
7. Measure the voltage between body ground and
steering angle sensor 5P connector terminals No. 2,
No. 3, and No. 4 individually.
STEERING ANGLE SENSOR 5P CONNECTOR
STR-A (GRN) STR-B
(PUR)
STR-D (BLU)
Wire side of female terminals
Is there 0.1 V or more?
−
YES Repair short to power in the wire between
the steering angle sensor and the VSA modulator-
control unit.
NO − Replace the steering angle sensor (see page
19-137).
＊０１