Honda Accord 2008 Manual page 862

07/11/02 08:45:52 61TA0000_140_0019
Symptom
Poor acceleration;
flares when
starting off in D, D3,
and R; stall speed
high when starting
off in 2
Poor acceleration;
flares when
starting off in D, D3,
and R; stall speed
high in R
Poor acceleration;
stall speed low in 2
and 1, and in D and
D3 in 1st and 2nd
Poor acceleration;
stall speed low in R
Probable Cause(s)
2nd clutch defective
1. Shift cable broken or out of
adjustment
2. 4th clutch defective
1. Shift solenoid valve E defective
2. Torque converter one-way clutch
defective
3. Engine output low
4. Torque converter clutch piston
defective
5. Lock-up shift valve defective
1. Engine output low
2. Torque converter clutch piston
defective
3. Lock-up shift valve defective
4. Torque converter one-way clutch
defective
Notes
• Check the 2nd clutch pressure.
• Inspect the clutch piston, the clutch piston check
valve, and the O-rings. Check the spring retainer
and the retainer seal for wear and damage.
Inspect the clearance between the clutch end-
plate and the top disc. If the clearance is out of
tolerance, inspect the clutch discs and the plates
for wear and damage. If the discs are worn or
damaged, replace them as a set. Inspect the
clutch wave-plate height. If the height is out of
tolerance, replace the wave-plate. If the discs and
the plates are OK, adjust the clearance with the
clutch end-plate.
• Check for a loose shift cable at the shift lever and
the transmission control shaft.
• Check the 4th clutch pressure in D and R.
• Inspect the clutch piston, the clutch piston check
valve, and the O-rings. Check the spring retainer
for wear and damage. Inspect the clearance
between the clutch end-plate and the top disc. If
the clearance is out of tolerance, inspect the
clutch discs and the plates for wear and damage.
If the discs are worn or damaged, replace them
as a set. Inspect the clutch wave-plate height. If
the height is out of tolerance, replace the wave-
plate. If the discs and the plates are OK, adjust
the clearance with the clutch end-plate.
• Check for a stored DTC, and check for loose
connectors.
• Inspect shift solenoid valve E for seizure, and the
O-rings for wear and damage.
• Replace the torque converter.
Replace the torque converter.
(cont'd)
14-17