Honda Accord 2008 Manual page 1146

07/11/02 09:20:41 61TA0000_140_0303
10. Release the brake pedal, and measure the voltage
between shift lock solenoid connector terminals
No. 1 and No. 2. The shift lever must be in P.
＊０４
IG1 (RED)
(Type A Shift Lever)
IG1 (BRN)
(Type B Shift Lever)
Is there battery voltage?
YES
between PCM connector terminal A28 and the shift
lock solenoid.
NO −
mechanism is OK, replace the shift lock solenoid
(see page 14-309).
SHIFT LOCK SOLENOID CONNECTOR
SLS (BLK)
(Type A Shift Lever)
SLS (PNK)
(Type B Shift Lever)
Wire side of female terminals
−
Repair short to body ground in the wire
Check the shift lock mechanism. If the
11. Turn the ignition switch to LOCK (0).
12. Jump the SCS line with the HDS.
13. Disconnect PCM connector A (49P).
14. Check for continuity between PCM connector
terminal A28 and shift lock solenoid connector
terminal No. 2.
PCM CONNECTOR A (49P)
SHIFT LOCK
SOLENOID CONNECTOR
SLS (BLK)
(Type A Shift Lever)
SLS (PNK)
(Type B Shift Lever)
Wire side of
female terminals
Is there continuity?
−
YES Substitute a known-good PCM (see page
14-8) and recheck.
NO − Repair open in the wire between PCM
connector terminal A28 and the shift lock solenoid
connector.
SLS (PNK)
Terminal side of
female terminals
(cont'd)
14-301
＊０５