Honda Accord 2008 Manual page 1767

07/11/02 09:37:12 61TA0000_200_0200
Seats
Front Seat-back Cover Replacement
Special Tools Required
KTC trim tool set SOJATP2014
Available through the American Honda Tool and
Equipment Program; call 888-424-6857
2-door
SRS components are located in this area. Review the
SRS component locations (see page 24-21) and the
precautions and procedures (see page 24-23) before
doing repairs or service.
• Check the operation of the driver's seat position
sensor after any of these actions (see page 24-42):
– Driver's seat position sensor replacement
– Cover plate (front side of driver's seat slide rail)
replacement
• Calibrate the ODS unit after any of the these actions
(see page 24-40):
– Front passenger's seat replacement (including any
seat components)
– Replacement of the seat weight sensors
– After a vehicle collision
NOTE:
• Put on gloves to protect your hands.
• Take care not to tear the seams of damage the seat
covers.
• On the passenger's seat, do not touch the OPDS
sensor in the seat-back pad, and keep it away from oil.
Oil can corrode the sensor causing it to fail.
• Use the appropriate tool from the KTC trim tool set to
avoid damage when removing components.
1. Remove the front seat (see page 20-180).
20-198
2. Driver's seat (10-way power seat): Remove the rear
seat access knob (A). Remove the screw, then
remove the rear seat access trim (B).
Fastener Location
: Screw, 1
3. From under the seat cushion, release the elastic
strap (A) from the seat cushion frame springs (B),
then pull the under cover (C) of the back cover back.
A
B
C
ＴＡ０８ＡＢＡＪ４６１２７０５３９５０ＫＢＡＴ００
B
A
B
A
＊０１
＊０２