Honda Accord 2008 Manual page 800

07/11/02 09:24:34 61TA0000_130_0027
NOTE: Place the clutch housing on two pieces of wood
thick enough to keep the mainshaft from hitting the
workbench.
1. Remove the detent bolts (A), 12 mm sealing
washers, springs, steel balls, and back-up light
switch (B).
＊０３
A
2. Remove the transmission hanger (C), 20 mm bolt
(D), and 20 mm sealing washer (E).
3. Remove the interlock bolt (A), change lever
assembly (B), and 8 x 14 mm dowel pins (C).
＊０４
Replace.
C
D
B
E
Replace.
C
B
4. Remove the drain plug (A), filler plug (B), 10 mm
flange bolt (C), and sealing washer (D).
G
5. Remove the output shaft (countershaft) speed
sensor (E), plain washer (F), and O-ring (G).
6. Loosen the 8 mm flange bolts in a crisscross
pattern in several steps, then remove them.
B
A
7. Remove transmission hanger A and transmission
hanger B.
B
D
A
D
F
C
E
(cont'd)
13-27
＊０５
D
＊０６
A