Honda Accord 2008 Manual page 971

07/11/02 08:48:34 61TA0000_140_0128
Automatic Transmission
DTC Troubleshooting (cont'd)
DTC P0735: Problem in 5th Clutch and 5th
Clutch Hydraulic Circuit (5th Gear Incorrect
Ratio)
NOTE: Before you troubleshoot, record all freeze data
and any on-board snapshot with the HDS, and review
General Troubleshooting Information (see page 14-4).
1. Warm up the engine to normal operating
temperature (the radiator fan comes on).
2. Make sure that the transmission is filled to the
proper level, and check for fluid leaks.
3. Drain the ATF (see step 3 on page 14-242) through a
strainer. Inspect the strainer for metal debris or
excessive clutch material.
Does the strainer have metal debris or excessive
clutch material?
−
YES Replace the transmission, then go to step 11.
NO − Replace the ATF (see page 14-242), then go to
step 4.
4. Measure the line pressure (see page 14-218).
Is the line pressure within the service limits?
YES − Go to step 5.
−
NO Repair the ATF pump and the regulator valve,
or replace the transmission, then go to step 11.
5. Measure the 5th clutch pressure (see page 14-218).
Is the 5th clutch pressure within the service
limits?
YES − Go to step 6.
NO − Shift valves A, B, and/or D are stuck. Repair
these valves and the hydraulic circuit, or replace
the transmission, then go to step 11.
14-126
6. Turn the ignition switch to ON (II).
7. Clear the DTC with the HDS.
8. Test-drive the vehicle in 5th gear with the shift lever
in D at speeds over 7 mph (12 km/h) with the
engine speed above 1,000 rpm for at least
12 seconds.
9. Check for Temporary DTCs or DTCs with the HDS.
Is DT C P07 35 indicated?
YES − Repair the 5th clutch, or replace the
transmission, then go to step 11.
NO − Go to step 10.
ＴＡ０８ＡＥＢＫ７７１０００９０７３５ＦＡＡＴ００