Honda Accord 2008 Manual page 1773

07/11/02 09:37:44 61TA0000_200_0206
Seats
Front Seat-back Cover Replacement (cont'd)
Special Tools Required
KTC trim tool set SOJATP2014
Available through the American Honda Tool and
Equipment Program; call 888-424-6857
4-door
SRS components are located in this area. Review the
SRS component locations (see page 24-19) and the
precautions and procedures (see page 24-23) before
doing repairs or service.
• Check the operation of the driver's seat position
sensor after any of these actions (see page 24-42):
– Driver's seat position sensor replacement
– Cover plate (front side of driver's seat slide rail)
replacement
• Calibrate the ODS unit after any of the these actions
(see page 24-40):
– Front passenger's seat replacement (including any
seat components)
– Replacement of the seat weight sensors
– After a vehicle collision
NOTE:
• Put on gloves to protect your hands.
• Take care not to tear the seams of damage the seat
covers.
• On the passenger's seat, do not touch the OPDS
sensor in the seat-back pad, and keep it away from oil.
Oil can corrode the sensor causing it to fail.
• Use the appropriate tool from the KTC trim tool set to
avoid damage when removing components.
1. Remove the front seat (see page 20-180).
20-204
2. With back cover: From under the seat cushion,
release the elastic strap (A) from the seat cushion
frame springs (B), then pull the under cover (C) of
the back cover back.
A
B
C
3. With back cover: Detach the clips, and release the
hooks (A) by pulling the bottom of the back cover
(B) back, then gently pull down the cover to release
the hooks (C) from the seat-back frame, and
remove the cover.
NOTE: Detach the clips and the hooks in the
numbered sequence as shown.
Fastener Locations
: Clip, 2
A
ＴＡ０８ＡＱＥＪ４６１２７０５３９５０ＫＢＡＴ００
B
A
C
B
A
＊０１
＊０２