Honda Accord 2008 Manual page 1044

07/11/02 09:17:34 61TA0000_140_0201
DTC P1717: Open in Transmission Range
Switch ATP RVS Switch Circuit
NOTE:
• Before you troubleshoot, record all freeze data and
any on-board snapshot with the HDS, and review
General Troubleshooting Information (see page 14-4).
• This code is caused by an electrical circuit problem
and cannot be caused by a mechanical problem in the
transmission.
1. Turn the ignition switch to ON (II).
2. Shift to R, and check the A/T R Switch in the Data
List with the HDS.
Is the A/ T R Switch ON?
YES − Go to step 3.
−
NO Check for proper transmission range switch
installation (see page 14-291), adjust the shift cable
(see page 14-283), then recheck.
3. Check the Reverse Switch in the Data List with the
HDS.
Is the Reverse Switch ON?
YES − Intermittent failure, the system is OK at this
time.
−
NO Go to step 4.
4. Turn the ignition switch to LOCK (0).
5. Disconnect the transmission range switch
connector.
6. Check for continuity between transmission range
switch connector terminal No. 10 and body ground.
TRANSMISSION RANGE SWITCH CONNECTOR
Wire side of female terminals
Is there continuity?
YES − Go to step 7.
−
NO Repair open in the wire between transmission
range switch connector terminal No. 10 and ground
(G101) (see page 22-22), or repair poor ground
(G101), then go to step 10.
7. Turn the ignition switch to ON (II).
8. Measure the voltage between transmission range
switch connector terminals No. 1 and No. 10.
TRANSMISSION RANGE SWITCH CONNECTOR
ATP RVS (WHT/RED)
Wire side of female terminals
Is there battery voltage?
YES − Go to step 9.
−
NO Repair open in the wire between PCM
connector terminal B23 and the transmission range
switch, then go to step 10.
ＴＡ０８ＡＥＢＫ７７１０００９１７１７ＦＡＡＴ００
GND (BLK)
GND (BLK)
(cont'd)
14-199
＊０１
＊０２