Secondary Shaft 2Nd Gear Axial Clearance Inspection - Honda Accord 2008 Manual

Hide thumbs Also See for Accord 2008:

Table of Contents

07/11/02 09:22:52 61TA0000_140_0353

Secondary Shaft 2nd Gear Axial Clearance Inspection

1. Install the thrust needle bearing (A), the needle

bearing (B), 2nd gear (C), the thrust needle bearing

(D), the 37 x 58 mm thrust washer (E), and the 2nd

clutch (F) on the secondary shaft (G), then secure

them with the snap ring (H). Do not install the

O-rings during inspection.

2. Measure the clearance between the snap ring (A)

and the 2nd clutch guide (B) using a feeler gauge

(C), in at least three places. Use the average as the

actual clearance.

Standard: 0.04 0.12 mm (0.002 0.005 in.)

ＴＡ０８ＡＥＢＥ１０４１１３５４１８１ＭＡＡＴ００

Table of Contents