Honda Accord 2008 Manual page 1515

07/11/02 09:35:41 61TA0000_190_0094
VSA System Components
DTC Troubleshooting (cont'd)
DTC 53-01: Motor Relay Stuck ON 1
DTC 53-12: Motor Relay Stuck ON 2
1. Turn the ignition switch to ON (II).
2. Clear the DTC with the HDS.
3. Turn the ignition switch to LOCK (0), then turn it to
ON (II) again.
4. Check for DTCs with the HDS.
Is DT C 53-01 or 53-12 indicated?
−
YES Go to step 5.
NO − Intermittent failure, the system is OK at this
time. Check for loose terminals at the VSA
modulator-control unit 36P connector. Refer to
intermittent failures troubleshooting (see page
19-47).
5. Turn the ignition switch to LOCK (0).
6. Disconnect the VSA modulator-control unit 36P
connector (see step 3 on page 19-142).
19-94
7. Check for continuity between VSA modulator-
control unit 36P connector terminal No. 36 and
body ground.
VSA MODULATOR-CONTROL UNIT 36P CONNECTOR
Wire side of female terminals
Is there continuity?
−
YES Go to step 8.
NO − Repair open in the wire between the VSA
modulator-control unit and body ground (G202).
ＴＡ０８ＡＥ４Ｋ８０１０００Ｒ５３０１ＦＡＡＴ０１
＊０１
MR-GND (BLK)