Honda Accord 2008 Manual page 1229

07/11/02 09:24:07 61TA0000_140_0386
Transmission End Cover
End Cover Installation (cont'd)
25. Install the transmission range switch (A) gently on
the selector control shaft (B) while holding it in the
N position with the 2.0 mm (0.08 in.) blade (C).
＊１２
B
26. Tighten the bolts on the transmission range switch
while you continue to hold it in the N position. Do
not move the transmission range switch when
tightening the bolts. Remove the feeler gauge.
＊１３
14-384
27. Connect the transmission range switch connector
C
A
28. Install the transmission range switch cover (D).
6 x 1.0 mm
29. Install a new gasket (B) on the transmission
12 N·m
(1.2 kgf·m, 8.7 lbf·ft)
30. Install a new O-rings (E) over the ATF joint pipes,
(A) securely, then install the harness clamps (B) on
the clamp bracket (C).
6 x 1.0 mm
12 N·m
(1.2 kgf·m,
8.7 lbf·ft)
A
B
housing, and install the ATF pipe (C) and the ATF
joint pipes (D).
NOTE: Be sure to install a new gasket with the blue
side toward the transmission housing.
B
D
C
6 x 1.0 mm
12 N·m (1.2 kgf·m, 8.7 lbf·ft)
and install A/T clutch pressure control solenoid
valve A.
D
C
E
A
＊１４
＊１５