Honda Accord 2008 Manual page 1737

07/11/02 09:36:11 61TA0000_200_0170
Dashboard
Column Cover Removal/Installation
(cont'd)
8. Remove the three screws (A, B), then remove the
lower column cover (C).
＊０４
Fastener Locations
A
9. Install the upper and lower column covers in the
reverse order of removal, and push the hooks into
place securely.
20-168 20-168
: Screw, 1 B : Screw, 2
B
B
A
Dashboard/Steering Hanger Beam
Removal/Installation
Special Tools Required
KTC trim tool set SOJATP2014
Available through the American Honda Tool and
Equipment Program; call 888-424-6857
SRS components are located in this area. Review the
SRS component locations, 2-door (see page 24-21),
4-door (see page 24-19) and the precautions and
procedures (see page 24-23) before doing repairs or
service.
NOTE:
• Put on gloves to protect your hands.
• Take care not to scratch the dashboard, the body and
the other related parts.
• Take care not to bend the brackets.
• Have an assistant help you when removing and
installing the dashboard/steering hanger beam.
• Use the appropriate tool from the KTC trim tool set to
avoid damage when removing components.
C
1. Do the battery terminal disconnection procedure
(see page 22-89), then wait at least 3 minutes
before beginning work.
2. Remove these items:
• Driver's dashboard lower cover (see page
20-152)
• Center console (see page 20-147)
• Dashboard center lower cover, both sides
(see page 20-156)
• Glove box (see page 20-160)
• Kick panels, both sides:
– 2-door (see page 20-97)
– 4-door (see page 20-99)
• A-pillar trim, both sides (see page 20-101)
• Steering column (see page 17-28)
• Shift lever housing, M/T model (see page 13-62)
• Shift lever, A/T model (see page 14-273)
ＴＡ０８Ａ００Ｊ２６２２０２０００００ＫＤＡＴ００