Honda Accord 2008 Manual page 1679

Hide thumbs Also See for Accord 2008:

Table of Contents

07/11/02 09:32:29 61TA0000_200_0112

Interior Trim

Trim Removal/Installation - Pillar Areas (cont'd)

Special Tools Required

KTC trim tool set SOJATP2014

Available through the American Honda Tool and

Equipment Program; call 888-424-6857

C-Pillar Trim - 2-door

SRS components are located in this area. Review the

SRS component locations (see page 24-21) and the

precautions and procedures (see page 24-23) before

doing repairs or service.

• Follow the C-pillar trim installation procedure

carefully; improper installation could cause the side

curtain airbag to deploy improperly and possibly

cause injury.

• Put on gloves to protect your hands.

• Use the appropriate tool from the KTC trim tool set to

avoid damage when removing components.

• Take care not to scratch the trim and the panels.

• The rear clip in the C-pillar trim (A) consists of a resin

grommet (B) and a metal pin (C). The grommet

expanded with the pin secures it to the body panel (D).

The grommet must be replaced with a new one when

the trim is reinstalled.

1. Lower the coat hanger (A), then remove the screw.

Fastener Location

2. Pry out the C-pillar lid cap (A) with the appropriate

trim tool, then remove it.

ＴＡ０８ＡＢ２Ｊ２６２７３４０００００ＫＤＡＴ６０

Chapters

Table of Contents