Honda Accord 2008 Manual page 1064

07/11/02 09:18:05 61TA0000_140_0221
11. Turn the engine off, then disconnect the A/T oil
pressure gauge from the line pressure inspection
port.
12. Install the sealing bolt in the line pressure
inspection port with a new sealing washer, and
tighten the sealing bolt to 18 N·m (1.8 kgf·m,
13 lbf·ft). Do not reuse the old sealing washer.
13. Connect the A/T oil pressure gauge to the 1st clutch
pressure inspection port (B).
＊０３
14. Remove the intake air duct and the air cleaner
assembly, and connect the A/T oil pressure gauge
to the 2nd clutch pressure inspection port (C). Then
temporarily install the air cleaner assembly and the
intake air duct.
＊０４
B
C
15. Start the engine, and shift into D.
16. Shift to 1st gear, and measure the 1st clutch
pressure at the 1st clutch pressure inspection port
(B) while holding engine speed at 2,000 rpm.
17. Shift up to 2nd gear, and measure the 2nd clutch
pressure at the 2nd clutch pressure inspection port
(C) while holding engine speed at 2,000 rpm.
Pressure Fluid Pressure
Standard
1st clutch 917 995 kPa −
(B) (9.35 10.15 kgf/cm , −
−
2nd clutch 133 144 psi)
(C)
18. Turn the engine off, then disconnect the A/T oil
pressure gauges from the 1st clutch pressure and
the 2nd clutch pressure inspection ports.
19. Install the sealing bolts in the 1st clutch pressure
and the 2nd clutch pressure inspection ports with
new sealing washers, and tighten the sealing bolts
to 18 N·m (1.8 kgf·m, 13 lbf·ft). Do not reuse the old
sealing washers.
Service Limit
868 kPa
2 2
(8.85 kgf/cm ,
126 psi)
(cont'd)
14-219