Honda Accord 2008 Manual page 952

07/11/02 08:48:07 61TA0000_140_0109
36. Reconnect all connectors.
37. Update the PCM if it does not have the latest
software (see page 11-231), or substitute a known-
good PCM (see page 14-8).
38. Test-drive the vehicle at speeds over 12 mph
(20 km/h) with the shift lever in D, and let the
transmission shift through all five gears.
39. Check for Temporary DTCs or DTCs with the HDS.
Is DT C P07 18 indicated?
−
YES Check for poor connections or loose
terminals between the input shaft (mainshaft)
speed sensor and the PCM. If the PCM was updated,
substitute a known-good PCM (see page 14-8), then
go to step 38. If the PCM was substituted, go to step
1.
−
NO Go to step 40.
40. Monitor the OBD STATUS for P0718 in the DTCs
MENU with the HDS.
Does the HDS indicate PASSED?
YES − If the PCM was updated, troubleshooting is
complete. If the PCM was substituted, replace the
original PCM (see page 11-232). If any other
Temporary DTCs or DTCs were indicated in step 39,
go to the indicated DTC's troubleshooting.
NO − If the HDS indicates FAILED, check for poor
connections or loose terminals between the input
shaft (mainshaft) speed sensor and the PCM. If the
PCM was updated, substitute a known-good PCM
(see page 14-8), then go to step 38. If the PCM was
substituted, go to step 1. If the HDS indicates NOT
COMPLETED, go to step 38.
14-107