Honda Accord 2008 Manual page 1074

07/11/02 09:18:09 61TA0000_140_0231
9. Remove the bolts securing the ATF cooler inlet line
brackets (B), then remove A/T clutch pressure
control solenoid valve A.
＊０３
E
D
F
10. Remove the ATF pipe (C), the ATF joint pipes (D),
the O-rings (E), and the gasket (F).
11. Check the fluid passage of A/T clutch pressure
control solenoid valve A for contamination.
6 x 1.0 mm
12 N·m
(1.2 kgf·m, 8.7 lbf·ft)
C
6 x 1.0 mm
12 N·m
B
(1.2 kgf·m, 8.7 lbf·ft)
12. Connect a jumper wire from the negative battery
terminal to A/T clutch pressure control solenoid
valve A connector terminal No. 2, and connect
another jumper wire from the positive battery
terminal to A/T clutch pressure control solenoid
valve A connector terminal No. 1. Make sure A/T
clutch pressure control solenoid valve A moves.
A
B
13. Disconnect one of the jumper wires, and check the
valve movement at the fluid passage in the valve
body mounting surface. If the valve binds or moves
sluggishly, or if the solenoid valve does not operate,
replace A/T clutch pressure control solenoid valve
A.
14. Clean the mounting surface and the fluid passage
of the A/T clutch pressure control solenoid valve
body and the transmission housing.
15. Install a new gasket on the transmission housing,
and install the ATF pipe and the ATF joint pipes.
Install new O-rings over the ATF joint pipes.
NOTE: Be sure to install a new gasket with the blue
side toward the transmission housing.
16. Install A/T clutch pressure control solenoid valve A.
17. Check the connector for rust, dirt, or oil, clean or
repair if necessary, then connect the connector
securely.
18. Install the intake air duct.
＊０４
14-229