Tire Pressure Sensor Location - Honda Accord 2008 Manual

Hide thumbs Also See for Accord 2008:

Table of Contents

07/11/02 09:29:28 61TA0000_180_0061

8. Turn the ignition switch to LOCK (0).

9. Disconnect the HDS from the DLC.

10. Test-drive the vehicle at 28 mph (45 km/h) or more

for at least 1 minute.

11. Make sure the low tire pressure indicator does not

12. Turn the ignition switch to LOCK (0).

13. Reduce the pressure in one tire until it is less than

the appropriate specification.

14. Turn the ignition switch to ON (II).

15. Test-drive the vehicle at 28 mph (45 km/h) or more

for at least 1 minute.

16. Make sure the low tire pressure indicator turns on,

then inflate the tire (see page 18-5).

17. Repeat step 12 to 16 for all the other tires.

18. Clear any DTCs with the HDS.

Tire Pressure Sensor Location

Special Tools Required

TPMS sensor initializer tool AKS0620006

Available through the Honda Tool and Equipment

Program; call 888-424-6857

NOTE: This procedure locates where the tire pressure

sensors number 1, 2, 3, 4 are mounted, when activated

by the TPMS sensor initializer tool.

1. With the ignition switch at LOCK (0), connect the

HDS to the data link connector (DLC) (A) located

under the driver's side of the dashboard.

2. Turn the ignition switch to ON (II).

3. Make sure the HDS communicates with the vehicle

and the TPMS control unit. If it doesn't,

troubleshoot the DLC circuit (see page 11-208).

4. Select Function Test from the mode menu, then

select Sensor Position Check on the HDS.

ＴＡ０８Ａ００Ｂ５４１７５１５９６３４ＭＡＡＴ００

Table of Contents