Honda Accord 2008 Manual page 1488

07/11/02 09:34:56 61TA0000_190_0067
DTC Troubleshooting
DTC 11-13: Right-front Wheel Speed Sensor
Circuit Malfunction
DTC 13-13: Left-front Wheel Speed Sensor
Circuit Malfunction
DTC 15-13: Right-rear Wheel Speed Sensor
Circuit Malfunction
DTC 17-13: Left-rear Wheel Speed Sensor
Circuit Malfunction
1. Turn the ignition switch to ON (II).
2. Clear the DTC with the HDS.
3. Turn the ignition switch to LOCK (0), then turn it to
ON (II) again.
4. Check for DTCs with the HDS.
Is DT C 11-13, 13-13, 15-13, and/ or 17 -13
indicated?
YES − Go to step 5.
−
NO Intermittent failure, the system is OK at this
time. Check for loose terminals between the wheel
speed sensor 2P connector and the VSA modulator-
control unit 36P connector. Refer to intermittent
failures troubleshooting (see page 19-47).
5. Turn the ignition switch to LOCK (0).
6. Disconnect the VSA modulator-control unit 36P
connector (see step 3 on page 19-142).
7. Disconnect the appropriate wheel speed sensor 2P
connector.
8. Check for continuity between the appropriate VSA
modulator-control unit 36P connector wheel speed
＋
sensor B and GND terminals (see table).
DTC VSA Modulator-control Unit 36P
Connector Terminal
11-13 No. 23
13-13 No. 19
15-13 No. 18
17-13 No. 21
VSA MODULATOR-CONTROL UNIT 36P CONNECTOR
FL-GND (GRN) RL-GND (RED)
RR-GND (PUR)
RR ＋ B (PNK)
＋
FL B (ORN) RL
Wire side of female terminals
Is there continuity?
−
YES Repair short in the wires between the
appropriate wheel speed sensor and the VSA
modulator-control unit.
NO − Go to step 9.
ＴＡ０８ＡＥ４Ｋ８０１０００Ｒ１１１３ＦＡＡＴ００
No. 10
No. 6
No. 4
No. 8
FR-GND (PUR)
FR ＋ B (LT GRN)
＋ B (BLU)
(cont'd)
19-67
＊０１