Mainshaft Bearing And Oil Seal Replacement - Honda Accord 2008 Manual

07/11/02 09:25:12 61TA0000_130_0053

Mainshaft Bearing and Oil Seal Replacement

Special Tools Required
• Oil seal driver 07JAD-PL90100
• Adjustable bearing puller, 20 40 mm
07736-A01000B
• Attachment, 42 x 47 mm 07746-0010300
• Driver 07749-0010000
• Slide hammer, 3/8''-16 UNF commercially available
1. Remove the ball bearing (A) from the clutch
housing (B) using the 20 40 mm adjustable
bearing puller (C) and a commercially available
3/8''-16 UNF slide hammer (D).
＊０１
2. Remove the oil seal (A) from the clutch housing. Be
careful when removing the oil seal so the clutch
housing is not damaged.
＊０２
−
−
D
C
07736-A01000B
A
A
3. Drive in the new oil seal from the transmission side
using the driver (A) and 42 x 47 mm attachment (B).
4. Drive in the new ball bearing (A) from the
transmission side using the oil seal driver (B).
B
ＴＡ０８ＡＡ７Ｅ３４１５０４３９５０１ＫＢＡＴ００
A
07749-0010000
B
07746-0010300
B
07JAD-PL90100
A
13-53
＊０３
＊０４