Honda Accord 2008 Manual page 1749

07/11/02 09:37:03 61TA0000_200_0182
Seats
Front Seat Removal/Installation
Special Tools Required
KTC trim tool set SOJATP2014
Available through the American Honda Tool and
Equipment Program; call 888-424-6857
SRS components are located in this area. Review the
SRS component locations, 2-door (see page 24-21),
4-door (see page 24-19) and the precautions and
procedures (see page 24-23) before doing repairs or
service.
• Check the operation of the driver's seat position
sensor after any of these actions (see page 24-42):
– Driver's seat position sensor replacement
– Cover plate (front side of driver's seat slide rail)
replacement
• Calibrate the ODS unit after any of the these actions
(see page 24-40):
– Front passenger's seat replacement (including any
seat components)
– Replacement of the seat weight sensors
– After a vehicle collision
NOTE:
• Put on gloves to protect your hands.
• When prying with a flat-tip screwdriver, wrap it with
protective tape to prevent damage.
• Take care not to scratch the body or tear the seat
covers.
• Use the appropriate tool from the KTC trim tool set to
avoid damage when removing components.
1. Tilt the steering wheel all the way up, and telescope
it all the way in.
20-180
2. 2-door passenger's seat: Carefully insert the tip of a
small screwdriver (A) through the hole in the back
of the front seat belt lower anchor cover (B) and
into the hole in the front seat belt lower anchor (C).
Unlock the lower anchor by pushing in on the
screwdriver. Remove the screwdriver, and then
detach the front seat belt anchor plate (D) and the
anchor cover from the lower anchor.
A
3. 4-door: Slide the front seat all the way forward.
Carefully pry up on the bottom of the anchor cover
(A) to release the hooks (B) and the tab (C), then
remove the cover by pulling it upward.
Driver's seat
ＴＡ０８ＡＥ４Ｊ４６１２７０５３９０１ＫＤＡＴ００
D
B
C
B
A
C
＊０１
＊０２