Honda Accord 2008 Manual page 1709

07/11/02 09:34:09 61TA0000_200_0142
Interior Trim
Carpet Replacement (cont'd)
4. Remove the footrest (A) by pulling it to detach the
clips.
＊０１
Fastener Locations
5. M/T model: Remove the bolts, then move the shift
lever housing as needed (see page 13-62).
6. A/T model: Remove the bolts securing the shift
lever mounting bracket (see page 14-278).
7. Detach the harness clips (A) fastening the
dashboard wire harness (B), and using a TORX T30
bit, remove the ground bolt (C). Disconnect the yaw
rate-lateral acceleration sensor connector (D).
A/T model
＊０２
C
6 x 1.0 mm
9.8 N·m
(1.0 kgf·m,
7.2 lbf·ft)
20-140
: Clip, 2
A
A
B
M/T model
C
6 x 1.0 mm
9.8 N·m
(1.0 kgf·m,
7.2 lbf·ft)
8. Remove the clip, and remove the right rear heater
joint duct (A). Disconnect the floor wire harness
connectors (B), and detach the harness clips (C)
fastening the floor wire harness (D).
A/T model
Fastener Location
: Clip, 1
C
A
D
B
A
D
B
A
C
D
B
C
＊０３
＊０４