07/11/02 08:48:09 61TA0000_140_0117
21. Connect PCM connector B (49P).
22. Turn the ignition switch to ON (II).
23. Measure the voltage between output shaft
(countershaft) speed sensor connector terminal
No. 2 and body ground.
*04
Is there about 5 V ?
YES
speed sensor (see page 14-236), then go to step 30.
−
NO
OUTPUT SHAFT (COUNTERSHAFT)
SPEED SENSOR CONNECTOR
NC (BLK/WHT)
Wire side of female terminals
−
Replace the output shaft (countershaft)
Go to step 24.
24. Turn the ignition switch to LOCK (0).
25. Disconnect PCM connector B (49P).
26. Check for continuity between PCM connector
terminal B38 and output shaft (countershaft) speed
sensor connector terminal No. 2.
PCM CONNECTOR B (49P)
NC (BLK/WHT)
Terminal side of
female terminals
Is there continuity?
YES
−
Go to step 36.
−
NO
Repair open in the wire between PCM
connector terminal B38 and the output shaft
(countershaft) speed sensor, then go to step 30.
OUTPUT SHAFT
(COUNTERSHAFT)
SPEED SENSOR
CONNECTOR
NC
(BLK/WHT)
Wire side of
female terminals
(cont'd)
14-115
*05