Honda Accord 2008 Manual page 1490

07/11/02 09:34:57 61TA0000_190_0069
11. Check for continuity between the appropriate VSA
modulator-control unit 36P connector terminal and
the wheel speed sensor 2P connector terminal (see
table).
11-13
13-13
15-13
17-13
＊０４
VSA MODULATOR-CONTROL UNIT 36P CONNECTOR
RR-GND (PUR)
Is there continuity?
YES
between the appropriate wheel speed sensor and
the VSA modulator-control unit.
NO −
DTC VSA Modulator-control Unit 36P
Connector Terminal
No. 23
No. 19
No. 18
No. 21
FL-GND (GRN) RL-GND (RED)
FR-GND (PUR)
RR ＋ B (PNK) FR ＋ B (LT GRN)
FL ＋ B (ORN) RL ＋ B (BLU)
Wire side of female terminals
− Repair short to body ground in the wire
Go to step 12.
12. Turn the ignition switch to ON (II).
13. Measure the voltage between body ground and the
appropriate VSA modulator-control unit 36P
connector terminal (see table).
DTC
No. 10
No. 6 11-13
No. 4 13-13
No. 8 15-13
17-13
VSA MODULATOR-CONTROL UNIT 36P CONNECTOR
RR-GND (PUR)
RR
Is there 0.1 V or more?
YES − Repair short to power in the wire between
the appropriate wheel speed sensor and the VSA
modulator-control unit.
NO − Go to step 14.
VSA Modulator-control Unit 36P
Connector Terminal
No. 23
No. 19
No. 18
No. 21
FL-GND (GRN) RL-GND (RED)
FR-GND (PUR)
＋ B (PNK) FR ＋ B (LT GRN)
FL ＋ B (ORN) RL ＋ B (BLU)
Wire side of female terminals
No. 10
No. 6
No. 4
No. 8
＊０５
(cont'd)
19-69