Honda Accord 2008 Manual page 951

07/11/02 08:48:07 61TA0000_140_0108
Automatic Transmission
DTC Troubleshooting (cont'd)
27. Turn the ignition switch to LOCK (0).
28. Disconnect PCM connector B (49P).
29. Check for continuity between PCM connector
terminal B19 and input shaft (mainshaft) speed
sensor connector terminal No. 1.
＊０６
PCM CONNECTOR B (49P)
VCC2 (YEL/BLU)
Terminal side of
female terminals
Is there continuity?
YES
−
NO
connector terminal B19 and the input shaft
(mainshaft) speed sensor, then go to step 30.
14-106
INPUT SHAFT
(MAINSHAFT)
SPEED SENSOR
CONNECTOR
VCC2 (YEL/BLU)
Wire side of
female terminals
− Go to step 36.
Repair open in the wire between PCM
30. Reconnect all connectors.
31. Turn the ignition switch to ON (II).
32. Clear the DTC with the HDS.
33. Test-drive the vehicle at speeds over 12 mph
(20 km/h) with the shift lever in D, and let the
transmission shift through all five gears.
34. Check for Temporary DTCs or DTCs with the HDS.
Is DT C P07 18 indicated?
−
YES Check for poor connections or loose
terminals between the input shaft (mainshaft)
speed sensor and the PCM, then go to step 1.
NO − Go to step 35.
35. Monitor the OBD STATUS for P0718 in the DTCs
MENU with the HDS.
Does the HDS indicate PASSED?
YES − Troubleshooting is complete. If any other
Temporary DTCs or DTCs were indicated in step 34,
go to the indicated DTC's troubleshooting.
NO − If the HDS indicates FAILED, check for poor
connections or loose terminals between the input
shaft (mainshaft) speed sensor and the PCM, then
go to step 1. If the HDS indicates NOT COMPLETED,
go to step 33.