Honda Accord 2008 Manual page 1720

07/11/02 09:34:15 61TA0000_200_0153
Dashboard
Instrument Visor Removal/Installation
Special Tools Required
KTC trim tool set SOJATP2014
Available through the American Honda Tool and
Equipment Program; call 888-424-6857
NOTE:
• Take care not to scratch the dashboard and its related
parts.
• Use the appropriate tool from the KTC trim tool set to
avoid damage when removing components.
1. Detach the clips fastening the column blind cover
(A) from the upper column cover (B) by hand.
＊０１
Fastener Locations
: Clip, 2
2. If necessary, detach the hooks (A), then remove the
column blind cover (B) from the instrument visor
(C).
＊０２
A
B
C
A
A
3. Gently pull out along the edge of the instrument
visor (A) to detach the clips (B, C) and the hooks (D),
and release the hooks (E) by pulling the visor out,
then remove the visor.
Fastener Locations
B : Clip, 2 C
D
E
4. Install the visor in the reverse order of removal,
and note these items:
• If the clips are damaged or stress-whitened,
replace them with new ones.
• Push the clips and the hooks into place securely.
B
ＴＡ０８Ａ００Ｊ２６２２０２３４７２１ＫＤＡＴ１０
: Clip, 4
E
D
A
C
C
C
B
B
C
E
20-151
＊０３