Honda Accord 2008 Manual page 1519

Hide thumbs Also See for Accord 2008:
Table of Contents

Advertisement

07/11/02 09:35:42 61TA0000_190_0098
VSA System Components
DTC Troubleshooting (cont'd)
DTC 61-01:
VSA Modulator-control Unit Initial
IG Low Voltage
DTC 61-21:
VSA Modulator-control Unit
Power Source Low Voltage 1
DTC 61-22:
VSA Modulator-control Unit
Power Source Low Voltage 2
DTC 61-23:
VSA Modulator-control Unit
Power Source Low Voltage 3
1. Turn the ignition switch to ON (II).
2. Clear the DTC with the HDS.
3. Turn the ignition switch to LOCK (0), then start the
engine.
4. Check for DTCs with the HDS.
Is DT C 61-01, 61-21, 61-22, or 61-23 indicated?
YES
Go to step 5.
NO
Intermittent failure, the system is OK at this
time. Check for loose terminals at the VSA
modulator-control unit 36P connector. Refer to
intermittent failures troubleshooting (see page
19-47).
5. Check and note BATTERY voltage in the VSA DATA
LIST with the HDS.
6. Using a voltmeter, measure and note the voltage
between the battery terminals.
NOTE: If the voltage is below 9.5 V, check the
battery (see page 22-88), and troubleshoot the
alternator regulator circuit (see page 4-28).
19-98
7. Compare the voltage noted in step 5 to the voltage
in step 6.
Is the dif f erence between the two voltage
readings less then 3 V ?
YES
Intermittent failure, the system is OK at this
time. Check for loose terminals at the VSA
modulator-control unit 36P connector. Refer to
intermittent failures troubleshooting (see page
19-47). If the code resets after clearing, go to step 8.
NO
Go to step 8.
8. Update the VSA modulator-control unit if it does
not have the latest software (see page 19-140). If
the unit already has the latest software, substitute a
known-good VSA modulator-control unit (see page
19-141).
9. Turn the ignition switch to LOCK (0), then start the
engine.
10. Check for DTCs with the HDS.
Is DT C 61-01, 61-21, 61-22, or 61-23 indicated?
YES
Check for loose terminals in the VSA
modulator-control unit 36P connector. If the VSA
modulator-control unit was updated, substitute a
known-good VSA modulator-control unit (see page
19-141), then retest. If the VSA modulator-control
unit was substituted, go to step 1.
NO
If the VSA modulator-control unit was
updated, troubleshooting is complete. If the VSA
modulator-control unit was substituted, replace the
original VSA modulator-control unit (see page
19-141). If any other DTCs are indicated, go to the
indicated DTCs troubleshooting.
TA08AE4K801000R6101FAAT00

Advertisement

Table of Contents

Troubleshooting

loading

Table of Contents