Clutch Replacement - Honda Accord 2008 Manual

07/11/02 09:15:18 61TA0000_120_0017

Clutch Replacement

Special Tools Required
• Clutch alignment disc 07JAF-PM7011A
• Ring gear holder 07LAB-PV00100
• Clutch alignment tool set 07PAF-0020000
• Clutch alignment shaft 07ZAF-PR8A100
• Attachment, 22 x 24 mm 07746-0010800
• Driver 07749-0010000
• Remover handle 07936-3710100
• Bearing remover shaft 07936-3710600
• Slide hammer 07936-371020A
Pressure Plate Inspection and Removal
1. Remove the transmission (see page 13-6).
2. Check the height of the diaphragm spring fingers
using the clutch alignment disc (A), clutch
alignment shaft (B), remover handle (C), and a
feeler gauge (D). If the height is more than the
service limit, replace the pressure plate.
Standard (New):
Service Limit:
＊０１
A
07JAF-PM7011A
C
07936-3710100
B
07ZAF-PR8A100
0.6 mm (0.02 in.) max.
0.8 mm (0.03 in.)
D
3. Install the ring gear holder (A) and the clutch
alignment tool set (B).
D
C
B
07PAF-0020000
4. To prevent warping, loosen the pressure plate
mounting bolts (C) in a crisscross pattern in several
steps, then remove the pressure plate (D).
5. Inspect the fingers of the diaphragm spring (A) for
wear at the release bearing contact area.
6. Inspect the pressure plate surface (A) for wear,
cracks, and burning.
ＴＡ０８ＡＥＡＥ３４１１６３０００００ＫＢＡＴ００
A
07LAB-PV00100
A
A
(cont'd)
12-15
＊０２
＊０３
＊０４