Honda Accord 2008 Manual page 1592

07/11/02 09:29:05 61TA0000_200_0025
13. Remove the rod fastener (A) from the outer handle
base (B), then replace it with a new one.
＊１５
14. Install the handle in the reverse order of removal,
and note these items:
• Reinstall the lock cylinder (driver's door) or the
outer handle holder (passenger's door) before
installing the outer handle cover.
• Make sure that the actuator connector is plugged
in properly, and that the cylinder cable and the
outer handle rod are connected securely.
• Make sure the door key cylinder/door locks
operate properly.
• Make sure the door handle works properly.
• When reinstalling the door panel, make sure the
plastic cover is installed properly and sealed
around its outside perimeter to seal out water.
Front Door Latch Replacement
NOTE: Put on gloves to protect your hands.
1. Remove the door panel and the inner handle:
B
• 2-door (see page 20-12)
• 4-door (see page 20-16)
2. Remove the plastic cover, as needed (see step 2 on
page 20-19).
3. Detach the rod fastener, and disconnect the outer
handle rod from the outer handle base (see step 12
on page 20-22).
4. Driver's door: Disconnect the cylinder cable from
the latch (see step 5 on page 20-20).
A
5. 2-door: Pull the glass run channel away as needed,
Replace.
and remove the bolt, then remove the center lower
channel by pulling it downward (see step 6 on page
20-20).
6. 4-door: Pull the glass run channel (A) away as
needed, and remove the bolt, then remove the
center lower channel (B) by pulling it downward.
Fastener Location
6 x 1.0 mm
8 N·m
(0.8 kgf·m, 6 lbf·ft)
ＴＡ０８Ａ００Ｊ１６１２６７２０８０１ＫＢＡＴ２０
: Bolt, 1
B
A
(cont'd)
20-23 20-23
＊０１