Honda Accord 2008 Manual page 1372

07/11/02 09:28:08 61TA0000_180_0039
Special Tools Required
Ball joint remover, 32 mm 07MAC-SL0A102
Hub Bearing Unit Replacement
1. Raise the rear of the vehicle, and support it with
safety stands in the proper locations (see page 1-9).
2. Remove the wheel nuts, and the rear wheel.
＊０２
3. Remove the brake hose mounting bolt (A).
＊０３
C
4. Remove the brake caliper bracket mounting bolts
(B), then remove the caliper assembly (C) from the
knuckle. To prevent damage to the caliper
assembly or brake hose, use a short piece of wire
to hang the caliper assembly from the
undercarriage. Do not twist the brake hose
excessively.
5. Remove the two washers (A).
NOTE: During installation, make sure the washers
are installed between the brake caliper bracket and
the knuckle.
A
6. Remove the rear brake disc (see page 19-34).
108 N·m
(11.0 kgf·m,
79.6 lbf·ft)
7. Remove the hub bearing unit (A) and O-ring (B).
A
8 x 1.25 mm
22 N·m
(2.2 kgf·m,
16 lbf·ft)
B
12 x 1.25 mm
12 x 1.5 mm
108 N·m
98.1 N·m
(11.0 kgf·m,
(10.0 kgf·m, 72.3 lbf·ft)
79.6 lbf·ft)
8. Check the hub bearing unit for damage and cracks.
B
Replace.
A
(cont'd)
18-39
＊０４
＊０５