Honda Accord 2008 Manual page 1527

07/11/02 09:36:24 61TA0000_190_0106
VSA System Components
DTC Troubleshooting (cont'd)
DTC 66-12: Pressure Sensor (Inside of VSA
Modulator-control Unit) Malfunction
1. Turn the ignition switch to ON (II).
2. Clear the DTC with the HDS.
3. Turn the ignition switch to LOCK (0), then turn it to
ON (II) again.
4. Check for DTCs with the HDS.
Is DT C 66-12 indicated?
−
YES Go to step 5.
NO − Intermittent failure, the system is OK at this
time.
5. Turn the ignition switch to LOCK (0).
6. Disconnect the steering angle sensor 5P connector
(see page 19-137).
7. Disconnect the VSA modulator-control unit 36P
connector (see step 3 on page 19-142).
19-106
8. Check for continuity between steering angle sensor
5P connector terminal No. 5 and body ground.
STEERING ANGLE SENSOR 5P CONNECTOR
Wire side of female terminals
Is there continuity?
YES − Repair short to body ground in the wire
between the steering angle sensor and the VSA
modulator-control unit.
NO − Go to step 9.
9. Turn the ignition switch to ON (II).
10. Measure the voltage between steering angle
sensor 5P connector terminal No. 5 and body
ground.
STEERING ANGLE SENSOR 5P CONNECTOR
Wire side of female terminals
Is there 0.1 V or more?
YES − Repair short to power in the wire between
the steering angle sensor and the VSA modulator-
control unit.
−
NO Go to step 11.
ＴＡ０８ＡＥ４Ｋ８０１０００Ｒ６６１２ＦＡＡＴ００
SVCC (ORN)
SVCC (ORN)
＊０１
＊０２