Honda Accord 2008 Manual page 1199

07/11/02 09:22:53 61TA0000_140_0356
Shafts and Clutches
Secondary Shaft 1st Gear Axial Clearance Inspection (cont'd)
5. Lift 1st gear (A) up while holding the secondary
shaft, and use the dial indicator (B) to read 1st gear
axial clearance.
＊０４
6. Measure the 1st gear axial clearance in at least
three places while moving 1st gear. Use the
average as the actual clearance.
Standard: 0.04 0.12 mm (0.002 0.005 in.)
14-354
A
− −
7. If the clearance is out of standard, remove the
40 x 51.5 mm thrust washer and measure its
thickness.
8. Select and install a new thrust washer, then
recheck.
THRUST WASHER, 40 x 51.5 mm
No. Part Number
1 90503-RCT-000
2 90504-RCT-000
3 90505-RCT-000
4 90506-RCT-000
B
5 90507-RCT-000
6 90508-RCT-000
9. After replacing the thrust washer, make sure the
clearance is within standard.
10. Disassemble the shaft and the gears.
Thickness
4.80 mm (0.189 in.)
4.85 mm (0.191 in.)
4.90 mm (0.193 in.)
4.95 mm (0.195 in.)
5.00 mm (0.197 in.)
5.05 mm (0.199 in.)