Honda Accord 2008 Manual page 934

Hide thumbs Also See for Accord 2008:
Table of Contents

Advertisement

07/11/02 08:47:45 61TA0000_140_0091
25. Measure the voltage between transmission range
switch connector terminals No. 3 and No. 10.
*04
TRANSMISSION RANGE SWITCH CONNECTOR
Is there battery voltage?
YES
NO
transmission range switch and PCM connector
terminal B16, then go to step 27.
26. Measure the voltage between transmission range
switch connector terminals No. 9 and No. 10.
*05
TRANSMISSION RANGE SWITCH CONNECTOR
Is there battery voltage?
YES
NO
transmission range switch and PCM connector
terminal B17, then go to step 27.
ATP D3 (BLU)
GND (BLK)
Wire side of female terminals
Go to step 26.
Repair open in the wire between the
ATP 2-1 (BRN)
GND (BLK)
Wire side of female terminals
Go to step 33.
Repair open in the wire between the
27. Reconnect all connectors.
28. Turn the ignition switch to ON (II).
29. Clear the DTC with the HDS.
30. Start the engine, disable the VSA by pressing the
VSA OFF switch, run the vehicle with the shift lever
in D until the vehicle speed reaches 30 mph
(48 km/h), then slow down and stop the wheels.
31. Check for Temporary DTCs or DTCs with the HDS.
Is DT C P07 06 indicated?
YES
Check for poor connections or loose
terminals between the transmission range switch
and the PCM, then go to step 1.
NO
Go to step 32.
32. Monitor the OBD STATUS for P0706 in the DTCs
MENU with the HDS.
Does the HDS indicate PASSED?
YES
Troubleshooting is complete. If any other
Temporary DTCs or DTCs were indicated in step 31,
go to the indicated DTC's troubleshooting.
NO
If the HDS indicates FAILED, check for poor
connections or loose terminals between the
transmission range switch and the PCM, then go to
step 1. If the HDS indicates NOT COMPLETED, go to
step 30.
33. Reconnect all connectors.
34. Update the PCM if it does not have the latest
software (see page 11-231), or substitute a known-
good PCM (see page 14-8).
35. Start the engine, disable the VSA by pressing the
VSA OFF switch, run the vehicle with the shift lever
in D until the vehicle speed reaches 30 mph
(48 km/h), then slow down and stop the wheels.
(cont'd)
14-89

Advertisement

Table of Contents

Troubleshooting

loading

Table of Contents