Honda Accord 2008 Manual page 1230

07/11/02 09:24:08 61TA0000_140_0387
31. Install a new gasket (A) and the ATF joint pipes (D)
on the transmission housing, and install new
O-rings (E) over the ATF joint pipes.
NOTE: Be sure to install a new gasket with the blue
side toward the transmission housing.
＊１６
32. Install A/T clutch pressure control solenoid valve B
and C, and the harness clamp brackets (F).
6 x 1.0 mm
12 N·m (1.2 kgf·m, 8.7 lbf·ft)
F
F
B, C
E
D
A
33. Install the ATF filter bracket (A) on the transmission
housing, then install the ATF cooler line/ATF filter
(B) with the line bolt (C) and new sealing washers
(D). Secure the ATF filter with its bracket (E).
D
A
B
C
28 N·m
(2.9 kgf·m, 21 lbf·ft)
34. Secure the line brackets (F) with two bolts.
35. Install the ATF cooler outlet line (G) with the line
bolt (H) and new sealing washers (I).
36. Install the breather cap (A) on the breather pipe (B).
B
37. Install the dipstick.
H
28 N·m
(2.9 kgf·m, 21 lbf·ft)
I
G
F
6 x 1.0 mm
12 N·m
(1.2 kgf·m,
8.7 lbf·ft)
E
A
14-385
＊１７
＊１８