Honda Accord 2008 Manual page 1624

07/11/02 09:29:52 61TA0000_200_0057
Power Mirror Replacement
1. Lower the door glass fully.
2. With your hand, carefully pull the top edge of the
door tweeter cover (A) out to detach the upper
hooks (B) and the clip, and remove the cover by
lifting it upward to release the bottom hooks (C).
Disconnect the door tweeter connector (D).
＊０１
Fastener Location
3. Disconnect the connector (A).
＊０２
Fastener Locations
: Nut, 3
4. While holding the mirror, remove the nuts securing
the mirror.
: Clip, 1
(Gray)
D
5 x 0.8 mm
5 N·m
(0.5 kgf·m, 4 lbf·ft)
A
5. While holding the mirror, push in on the connector
clip (A), then push out to remove the mirror (B).
Take care not to scratch the door.
A
B
B
6. Install the mirror in the reverse order of removal,
and note these items:
• Make sure the connector is plugged in properly.
C
• If the clip is damaged or stress-whitened, replace
it with a new one.
• Push the clip and the upper hooks on the cover
into place securely.
ＴＡ０８Ａ００Ｊ３４３０００４４０５１ＫＢＡＴ１０
A
20-55
＊０３